Lantronix 900-588 manual Getting Started, Physically Connecting the Unit, Required Information

3. Getting Started

This chapter covers the steps required to get an embedded device physically connected.

Physically Connecting the Unit

The following diagram shows a properly installed Micro125. Other devices connect in a similar manner.

Figure 3-1. Evaluation Board Connected to Serial Device and Network

10/100 Ethernet

J1

CON2

+5

RS232

1.Connect a computer or serial device to your unit.

2.Connect an Ethernet cable to the RJ-45 Ethernet port.

3.Supply power to your unit using the power supply that was included in the packaging.

Note: The required input voltage for the Micro125 is 5VDC (+/-5% at ~200 mA). Other devices may require a different voltage.

4. Supply power to the serial device.

Required Information

Hardware Address

You need to know the unit’s hardware address (also known as the MAC address), which is on the product label. It is in the format: 00-20-4a-XX-XX-XX, where the XXs are unique numbers assigned to the product.

Hardware Address: 00-20-4a-_____-_____-_____

Micro125 User Guide 12