5: Configuration Using Web Manager
3. Enter the following (as necessary):
Dynamic IP Setting Description
BOOTP
Select Enable to permit the Bootstrap Protocol (BOOTP). server to assign
the IP address from a pool of addresses automatically. Enable is the
default.
DHCP
Select Enable to permit the Dynamic Host Configuration Protocol (DHCP) to
assign a leased IP address to the Micro125 unit automatically. Enable is the
default.
AutoIP
Select Enable to permit the Micro125 to generate an IP in the 169.254.x.x
address range with a Class B subnet. Enable is the default.
DHCP Host Name
Enter the desired host name for the Micro125.
Note: Disabling BOOTP, DHCP, and AutoIP (all three checkboxes) is not advised as the only
available IP assignment method will then be ARP or serial port.
4. When you are finished, click the OK button.
5. On the main menu, click Apply Settings.
Static IP Address Configuration
You manually assign an IP address to the unit and enter related network settings.
To assign an IP address manually:
1. On the main menu, click Network.
2. Select Use the following IP configuration.
3. Enter the following (as necessary):
Static IP Settings Description
IP Address
If DHCP is not used to assign IP addresses, enter it manually in decimal-
dot notation. The IP address must be set to a unique value in the network.
Subnet Mask
A subnet mask defines the number of bits taken from the IP address that
are assigned for the host part.
Default Gateway
The gateway address, or router, allows communication to other LAN
segments. The gateway address should be the IP address of the router
connected to the same LAN segment as the unit. The gateway address
must be within the local network.
DNS Server
The DNS server allows the name of a remote machine to be resolved
automatically. Enter the IP address of the DNS server. If the device is
DHCP enabled, the DHCP server provides the DNS server IP address,
which will override this configured value.
Note: This setting is applicable only in Manual Connection mode.
4. When you are finished, click the OK button.
5. On the main menu, click Apply Settings.
Micro125 User Guide 21