8: Setup Mode: Channel Configuration

If this sequence is not followed, the unit remains in data transfer mode.

 

 

 

Table 8-10. Modem Mode Commands

 

 

 

 

 

Modem Mode

 

Function

 

Command

 

 

 

ATDTx.x.x.x,pppp,

 

Makes a connection to an IP address (x.x.x.x) and a remote port

 

 

 

ATDTx.x.x.x/pppp, or

 

 

 

number (pppp).

 

ATDTx.x.x.x:pppp

 

 

 

 

 

 

 

 

 

ATDTx.x.x.x

 

Makes a connection to an IP address (x.x.x.x) and the remote port

 

 

number defined within the unit.

 

 

 

 

 

 

 

 

ATD0.0.0.0

 

Forces the unit into Monitor Mode if a remote IP address and port

 

 

number are defined within the unit.

 

 

 

 

 

 

 

 

ATD or ATDT

 

Forces the unit into Monitor Mode if a remote IP address and port

 

 

number are not defined within the unit.

 

 

 

 

 

 

 

 

ATDx.x.x.x

 

Makes a connection to an IP address (x.x.x.x) and the remote port

 

 

number defined within the unit.

 

 

 

 

 

 

 

 

ATH

 

Hangs up the connection (Entered as +++ATH ).

 

 

 

 

 

 

 

Enables or disables connections from the network going to the serial

 

 

 

port.

 

 

 

n=0 disables the ability to make a connection from the network to the

 

ATS0=n

 

serial port.

 

 

n=1-9 enables the ability to make a connection from the network to

 

 

 

 

 

 

the serial port.

 

 

 

n>1-9 is invalid.

 

 

 

 

 

 

 

Enables or disables character echo and responses.

 

ATEn

 

n=0 disables character echo and responses.

 

 

 

 

 

 

n=1 enables character echo and responses.

 

 

 

 

 

 

 

Enables numeric response or full verbose.

 

ATVn

 

n=0 enables numeric response.

 

 

 

 

 

 

n=1 enables full verbose.

 

 

 

 

Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V.

Send the Escape Sequence (+++) in Modem Mode

Send ‘+++’ in Modem Mode (Y) ? _

Disable or enable the Micro125’s ability to send the escape sequence. The default is Y (Yes) (send the escape sequence).

Micro125 User Guide

50

Page 50
Image 50
Lantronix 900-588 manual Send the Escape Sequence +++ in Modem Mode, Modem Mode Function Command