8: Setup Mode: Channel Configuration

Table 8-11. Disconnect Mode Options

 

Disconnect Mode Option

 

 

7

 

 

6

 

 

5

 

 

4

 

 

3

 

 

2

 

 

1

 

 

0

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Disconnect when Modem Control In is not asserted (6)

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Ignore Modem Control In

 

0

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Telnet Com Port Cntrl and terminal type setup (1)

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Channel (port) password (2)

 

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hard disconnect (3)

 

 

 

 

 

0

 

 

 

 

 

 

 

 

 

 

 

Disable hard disconnect

 

 

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

State LED off with connection (4)

 

 

 

 

 

 

 

 

1

 

 

Disconnect with EOT (^D) (5)

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(1)The Telnet Com Port Control feature is used in conjunction with Com Port Redirector. The unit sends the Terminal Type upon an outgoing connection.

(2)A password is required for a connection to the serial port from the network.

(3)The TCP connection closes even if the remote site does not acknowledge the disconnection.

(4)When there is a network connection to or from the serial port, the state LED turns off instead of blinking.

(5)When Ctrl+D or Hex 04 is detected, the connection is dropped. Both Telnet Com Port Cntrl and Disconnect with EOT must be enabled for Disconnect with EOT to function properly. Ctrl+D is only detected going from the serial port to the network.

(6)When Modem Control In transitions from a high state to a low state, the network connection to or from the serial port drops.

Micro125 User Guide

52

Page 52
Image 52
Lantronix 900-588 manual Disconnect Mode Options