Manuals / Patton electronic / Computer Equipment / Modem

Patton electronic 3202 manual Vlan, VLAN Mode Options, Disable 802.1Q Tag VLAN Port-Based VLAN

Models: 3202

1 106

Download 106 pages 9.27 Kb

Page 75

Table 22. VLAN Mode Options

Model 3202 Getting Started Guide	5 • Console and Telnet configuration

VLAN

Virtual LAN (VLAN) is deﬁned as a group of devices on one or more LANs that are conﬁgured so that they can communicate as if they were attached to the same wire, when in fact they are located on a number of dif- ferent LAN segments. Because VLAN is based on logical instead of physical connections, it is extremely ﬂexi- ble.

You can setup the Virtual LAN (VLAN) parameters in VLAN command. The Model 3202 supports VLAN- to-PVC only for bridge mode operation, i.e., the VLAN spreads over both the CO and CPE sides, where there is no layer 3 routing involved. The unit supports up to 8 active VLANs with shared VLAN learning (SVL) bridge out of 4096 possible VLANs speciﬁed in IEEE 802.1Q.

The vlan command menu lists commands for setting up the DSL port. Move the cursor “ >>” to vlan in the setup menu and press Enter. The following menu displays:

>> mode	Trigger virtual LAN		function
modify	Modify virtual LAN table
pvid	Modify port	default	VID
link_mode	Modify port	link type
list	Show VLAN configuration

To activate the VLAN function, move the cursor “ >> “ to mode and press Enter. The products support two types of VLAN: 802.1Q and Port-Based.

802.1Q deﬁnes the operation of VLAN bridges that permit the deﬁnition, operation, and administration of VLAN topologies within a bridged LAN infrastructure. Port-Based VLANs are VLANs where the packet for- warding decision is based on the destination MAC address and its associated port.

Mode

You can choose from two types of VLANs: 802.1Q Tag-Based VLAN or Port Based VLAN. If you are not going to use the VLAN function, set this option to Disable.

-----------------------------------------------------------------------------

Command: setup vlan mode <Disable8021QPort>

Message: Please input the following information.

Trigger VLAN function (TAB Select) <Disable>:

-----------------------------------------------------------------------------

Table 22 shows the options available within the VLAN mode command menu:

	Table 22. VLAN Mode Options

Menu	Options

VLAN Mode	Disable 802.1Q Tag VLAN Port-Based VLAN

Setup Command Menu

75

Image 75

Patton electronic 3202 manual Vlan, VLAN Mode Options, Disable 802.1Q Tag VLAN Port-Based VLAN

Contents

Sales Ofﬁce +1 301 RocketLink Model2Base-TL Ethernet First Mile G.SHDSL Modem Getting Started Guide7622 Rickenbacker Drive Gaithersburg, MD 20879 USA Tel +1 301 Summary Table of Contents Hardware installation Table of ContentsSummary Table of Contents Table of ContentsTable of Contents 4 Web configuration5 Console and Telnet configuration A Compliance information 6 Contacting Patton for assistancePort pin-outs SpecificationsList of Figures Model 3202 Getting Started Guide List of Tables About this guide AudienceStructure Precautions impaired functioningNote A note presents additional information or interesting sidelights the Model 3202 ﬁrst Safety when working with electricityPreventing Electrostatic Discharge Damage tected by a circuit breakerGeneral observations Clean the case with a soft slightly moist anti-static clothProtect the unit from moisture, vapors, and corrosive liquids Typographical conventions used in this document General conventionsGaramond blue type Chapter 1 General information Chapter contentsModel 3202 overview Model 3202 front panel LED descriptionsRocketLink Port descriptions Model 3202 rear panelGround terminal Reset buttonChapter contents Chapter 2 Applications overviewIntroduction Typical applicationFigure 4. Model 3202 application Distance charts Distance Chart 3200 Series Per Wire PairDistance Chart Model 3202/4W 4 Wire/2 Pair Distance Chart Model 3202/8W 8 Wire/4 Pair Hardware installation ChapterChapter contents Planning the installation Create a network diagram Gather IP related informationIntroduction Network diagram AC Power MainsIP related information Unpacking the Model Installing the ModelConnecting cables Location and mounting requirementsGrounding the Model 3202 and connecting power Telnet conﬁguration requirements Conﬁguring the ModelWeb conﬁguration requirements Console conﬁguration requirementsWeb conﬁguration Chapter contentsChapter Upgrade 4 Web configurationSNMP Administration Configuration ToolIntroduction Setting Up the WMITCP/IP setup System LoginBasic Configuration Options Operation mode and MGMT portBasic Conﬁguration Options 4 Web configurationSubnet Mask Host Name SOHO DHCP serverPage IP Address Subnet Mask Gateway DNS Server 1 DNS Server 2 Review and save basic setup changesAnnex Type Advanced Conﬁguration OptionsLINE Line TypeLine Probe TCPAM TypeMain Rate SNR MarginVLAN WAN4 WAN5 4 Web configurationAdvanced Configuration Options Backbone802.1Q Tag-Based VLAN Figure 16. 802.1Q Tag-Based VLAN pageFigure 17. VLAN tag ﬁeld 802.1Q VLAN Figure 18. 802.1Q VLAN diagramually or dynamically using Generic VLAN Routing Protocol GVRP. However, if you want a port on this Model 3202 to participate in one or more VLANs, but none of the intermediate network devices nor the host at the other end of the connection supports VLANs, then you should add this port to the VLAN as an untagged port Figure 19. Port-Based VLAN page Port-Based VLANTPID Tag Protocol Identiﬁer Enter 33024 for IEEE802.1Q Port-Based QinQQuality of Service QoS Figure 23. QoS - Port Based Priority page Port Based PriorityVLAN Tag Priority Figure 24. QoS - VLAN Tag Priority pageFigure 25. IEEE 802.1Q Tagged Frame for Ethernet 0 default 41,25 Queue 40,35 Queue 4,5 Queue 6,7 Queue IP DSCP PriorityStays the sameused for IP routing Protocols Express Forwarding EFBest effort Figure 28. QoS - IP DSCP Priority page Rate Control Figure 29. Rate Control pageFigure 30. Rate Control options Status Options LINE StatusMGMT Status Administration Options Security AdministrationLAN Status Figure 36. Remote Management Host section User ProﬁlesRemote Management Hosts Figure 35. Model 3202 conﬁguration modesSNMP Administration Click Modify to set up community pools Community PoolUtility Options Trap Host PoolSystem Information Conﬁguration Tool Figure 43. Logout page UpgradeLogout Figure 42. Upgrade pageRestart The following screen displaysUtility Options Console and Telnet conﬁguration Chapter contentsChapter Model 3202 Getting Started Guide 5 Console and Telnet configurationTable 15. Console settings Log in using TelnetInterface commands Log in to the console interfaceWindow structure Menu tree for authorized users Main Menu TreeFigure 49. Main menu for unauthorized users Menu tree for unauthorized users5 Console and Telnet configuration Figure 48. Main screen for authorized usersEnable Command Menu G.SHDSL Setup Command MenuAnnex Type ModeLink Maximum Main RateClear Use the clear command to reset the CRC error countLine Probe VLAN Table 22. VLAN Mode OptionsVLAN Mode Disable 802.1Q Tag VLAN Port-Based VLANUse the pvid command to change the member port to untagged members LAN2 Port link type TAB Select AccessModel 3202 Getting Started Guide LAN1Mode Table 26. Queue Schedule Types Queue WeightQueue Schedule Table 25. Queue Weight OptionsVLAN Tag Priority QoS Port-Based Priority QoSSet up queue index 0, 1, 2 or 3 on each DSCP IP DSCP Priority QoSRate ListMGMT DHCPaddress MGMT IP address and subnet mask DHCP Fixed Host DHCP ServerFactory Default DNS ProxyHost Name Status Command Menu G.SHDSL StatusInterface Status Write Command Show Command MenuPing Command Reboot CommandAdministration Command Menu User ProﬁleModify/Add User Security Telnet TCP PortLegal IP Address Pool Community SNMP5 Console and Telnet configuration Validate Set to Enable or DisableAccess right Set to Read only, Read Write or Denied Trap hostSupervisor ID Version Set to Disable, Version 1 or VersionSupervisor Password and ID Supervisor PasswordRestore system conﬁguration Utility Command MenuUpgrade main software Backup system conﬁgurationPress “y” to exit the system. A conﬁrmation screen displays Exit CommandModel 3202 Getting Started Guide5 Console and Telnet configuration Exit CommandChapter contents Chapter 6 Contacting Patton for assistanceIntroduction Warranty Service and Returned Merchandise Authorizations RMAsWarranty coverage Contact informationRMA numbers Out-of-warranty serviceReturns for credit Return for credit policyChapter contents Appendix A Compliance informationAuthorized European Representative ComplianceRadio and TV interference FCC Part CE Declaration of ConformityChapter contents Appendix B SpeciﬁcationsG.SHDSL Speciﬁcations G.SHDSL ConnectorEthernet Connector Management ConnectorWeight Front Panel IndicatorsPower Supply DimensionsChapter contents Appendix C Port pin-outsModel 3202 Getting Started Guide Console portPins 1 & 3 are IntroductionC Port pin-outs EthernetNote Pins not listed are not used Model 3202 Getting Started Guide