9: Setup Mode: Advanced Settings
Default Settings (Option 7)Select 7 to reset the unit’s channel configuration and expert settings to the default settings .
The server configuration settings for IP address, gateway IP address, a nd netmask remain
unchanged. The specific settings that this option changes are listed below:
Channel 1 and Channel 2 Configuration Defaults
Channel Setting Default Configuration
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C)
Flow
00 (no flow control)
Port number
10001 (channel 1)
10002 (channel 2)
Connect Mode
C0 (always accept incoming connection; no active
connection startup)
Send '+++' in Modem Mode
Enabled
Show IP addr after 'RING'
Enabled
Auto increment source port
Disable
Hostlist retry counter
3
Hostlist retry timeout
250 (msec)
Start character for serial channel 1
0x0D (CR)
All other parameters
0
Expert Settings Defaults
Expert Setting Default Configuration
TCP Keepalive time in s
45
ARP Cache timeout in s
600
Disable Monitor Mode @ bootup
No
HTTP Port Number
80
MTU Size
0 (resulting in an operational value of 1400)
TCP Re-Transmission Timeout
(500-4000)
500 (ms)
Alternate MAC
Disabled ( for OEM use only)
Ethernet Connection Type
0 (auto-negotiate)