Miller Electric 30A, 15A manual Replacing Canister Inlet Guide, Replacing Spool Canister

6-5. Replacing Canister Inlet Guide

			1	Top Cover
			2	Pressure Roll Assembly
			Cut off welding wire where it enters
			pressure roll assembly area.
			3	Nozzle
1	7		Pull wire out nozzle.
	6		4	Thumbscrew
2	5	4	5	Canister Cover
			Loosen thumbscrew and remove
			cover.
			6	Wire Spool
			7	Spool Brake Thumbnut
			Loosen thumbnut, retract wire onto
			spool, secure, and remove spool.
3			8	Canister Inlet Guide
			Turn counterclockwise to remove.
			Install new guide.
			Reinstall spool and thread welding
			wire (see Section 4-3).
	8		Close pressure roll assembly. Ad-
			just spool brake pressure and drive

roll pressure if necessary (see Sec- tion 4-8).

Reinstall covers.

Tools Needed:

			Ref. 150 436-D / Ref. 149 967-H
6-6. Replacing Spool Canister
		1	Top Cover
		2	Pressure Roll Assembly
	5	Cut off welding wire where it enters
		pressure roll assembly area.
		3	Nozzle
		Pull wire out nozzle.
1		4	Thumbscrew (Canister
			Rotation)
		Turn thumbscrew counterclock-
		wise three full turns.
		5	Spool Canister
4		Remove as shown. Push new can-
		ister into wire drive housing until ful-
		ly seated. Tighten thumbscrew.
3		Install spool and thread welding
	2	wire (see Section 4-3).
		Close pressure roll assembly. Ad-
		just spool brake pressure and drive
		roll pressure as necessary (see
		Section 4-8).
		Reinstall covers.

Tools Needed:

Ref. 149 967-H

OM-1213 Page 19