SECTION 3 – INSTALLATION
3-1. Installing Wire Guides And Drive Rolls
1
6
23
Side View
7
8
5 4
3
9
Tools Needed:
When changing wire size or type, check drive roll and guide size (see Table
1Wire Guide Securing Screw
2Inlet Wire Guide
3Intermediate Wire Guide
Loosen wire guide screws.
Slide tip as close to drive rolls as possible without touching. Tighten screw.
4Drive Gear
5Pressure Gear
Drive and pressure gears installed before unit is shipped from factory.
6Pressure Gear Assembly Open pressure gear assembly.
7Drive Roll
8Gear Securing Bolt
9Drive Roll Securing Screw
Install correct drive roll for wire size and type using supplied hardware.
Close pressure gear assembly.
7/16 in
