Miller Electric Big 40 WG manual Servicing Fuel And Lubrication Systems

8-8. Servicing Fuel And Lubrication Systems

3 1

2

	6	5	4
				Tools Needed:
				802 731 / Ref. 801 434
Y Stop engine and let cool.		maintenance label for oil/filter change in-	to open sludge drain valve. Close valve
Y After servicing, start engine and		formation.	when sludge has drained. Remove hose.
		To drain sludge from fuel tank:	Close door.
	check for fuel leaks. Stop engine,
	tighten connections as necessary,	Y Beware of fire. Do not smoke and	To replace fuel filter:
	and wipe up spilled fuel.
		keep sparks and flames away from	5	Fuel Line
1	Oil Filter	drained fuel. Dispose of drained fuel
2 Oil Drain Valve And Hose		in an environmentally-safe manner.	6	Fuel Filter
		Do not leave unit unattended while	Remove clamps and filter. Install new filter
3	Oil Fill Cap/Dipstick
		draining fuel tank.
			and clamps. Inspect fuel lines and replace
4 Fuel Tank Sludge Drain Valve		Y Properly lift unit and secure in a level
			if cracked or worn. Wipe up any spilled fuel.
		position. Use adequate blocks or	Start engine and check for leaks.
		stands to support unit while drain-
To change oil and filter:
		ing fuel tank.	Y Stop engine, tighten connections as
Route oil drain valve and hose through hole		Attach 1/2 ID hose to drain valve. Put metal		necessary, and wipe up spilled fuel.
in base. See engine manual and engine		container under drain, and use screwdriver	Close door.

OM-4405 Page 40