4-6. Wire Type, Size, And Feed Speed Capability Table
Motor Speed | Wire Type | Wire Size | Feed Speed Capability | ||
|
|
|
| ||
Standard | All | .023 To 5/64 in (0.6 To 2 mm) | 50 To 780 ipm (1.3 To 19.8 mpm) | ||
|
|
|
| ||
Standard | All | 3/32 To 7/64 in (2.4 To 2.8 mm) | 50 To 700 ipm (1.3 To 17.8 mpm) | ||
|
|
|
|
| |
Standard | All | 1/8 in (3.2 mm) | 50 To 300 ipm (1.3 | To 7.6 mpm) | |
|
|
|
|
| |
Optional High | All | .023 To 5/64 in (0.6 To 2 mm) | 92 To 1440 ipm (2.3 | To 35.6 mpm) | |
Speed | |||||
|
|
|
| ||
|
|
|
|
| |
4-7. Motor Start Control
2
1
3 
To change wire feed starting speed, proceed as follows:
Turn Off wire feeder and welding power source.
Remove wrapper.
1 Front Panel
Front panel shown open for illustra- tion purposes.
2 Left Side Inner Control Panel
It may be necessary to remove pan- el to access Motor Start Control. Remove panel only as far as re- quired if options are attached to panel.
3Motor Board PC1
4Motor Start Control Poten- tiometer R70
Turn potentiometer clockwise to in- crease time it takes the motor to ramp up to speed. Remove protec- tive white rubber cap before making adjustment. Adjust potentiometer R70 using a small nonconductive screwdriver.
Reinstall left side inner control pan- el if it was removed.
Reinstall wrapper.
Tools Needed:
1/4 in
Ref. 143
