SECTION 5 – OPERATION
5-1. Front Panel Controls
3
4
5
6
7 
8 
9 
10
| 1 |
| 2 |
| 3 |
Schedule A | 4 |
| 5 |
| 6 |
Schedule B |
|
| 7 |
| 8 |
| 9 |
| 10 |
1Voltmeter (Optional) (See Section
2Wire Speed Meter (Optional)
Factory set to display inches per minute. If display of meters per minute is desired, see Section
3 Schedule A Wire Speed Control
The scale is calibrated in inches per minute x 100 and meter per minute.
4Schedule A Voltage Control (Optional)
.For dual schedule applications, a dual schedule switch is required for the gun. Obtain a proper dual schedule switch and install according to its instructions.
5Schedule B Indicator Light (Optional)
6Schedule B Wire Speed Control (Optional)
7Schedule B Voltage Control (Optional)
8Press To Set Button (Optional)
Press and hold button to preset Schedule B wire feed speed and/or voltage.
9Left And Right Indicator Lights
10Jog/Purge Switch
Push up to momentarily feed welding wire at speed set on Wire Speed control without en- ergizing welding circuit or shielding gas valve.
Push down to momentarily energize gas valve to purge air from gun or adjust gas reg- ulator.
Center position is off.
