Miller Electric XLix, Elitet manual Installing Optional Magnifying Lens, Xlix

SECTION 7 − INSTALLING OPTIONAL MAGNIFYING LENS

.To prevent lens fogging, install flat side of magnifying lens toward auto-darkening lens.

XLi –

Magnifying lenses can be adapted to the XLi helmet as follows:

1Pull outside lens cover/holder free from helmet.

2Position magnifying lens over auto-darkening lens between the four center- ing tabs.

3Reinstall outside lens cover/holder over top of magnifying lens.

4Reverse procedure to remove magnifying lens.

Xlix –

Installation:

1Locate magnifying lens holding tabs on lens assembly on inside of helmet.

2Place left side of the magnifying lens under the left side holding tabs.

3Gently push down on right side of magnifying lens. Both sides of lens should snap in place.

Removal:

1Remove helmet external shade control knob by prying off with a screwdriver or pulling off with a pliers.

2Remove the shade control retaining nut and allow the control to fall free in- side the helmet.

3Remove front lens cover frame by sliding it up toward top of helmet.

4Place one hand inside helmet and apply slight pressure to the bottom of the lens assembly. With other hand, push down on the two bottom retaining tabs on the front of the helmet. Catch lens assembly as it is released from helmet.

5Slide magnifying lens up and away from the lens holding tabs.

Elite −

1Remove lens holding frame (with auto-darkening lens) from helmet shell.

2Remove auto-darkening lens from lens holder.

3Position lens holder with magnifying lens holding tabs facing toward you. From the bottom up, slide magnifying lens into position. (Slide magnifying lens up or down slightly as desired.)

4Reinstall the auto-darkening lens in the lens holder.

5Reverse procedure to remove magnifying lens.

Page 12