FIRE OR EXPLOSION hazard.
D Do not overheat parts and adhesive.
DWatch for fire; keep extinguisher nearby.
DKeep flammables away from work area. D Do not locate unit on, over, or near combustible surfaces. D Do not install unit near flammables.
D Do not operate unit in explosive atmosphere.
INDUCTION HEATING can cause burns.
DHot parts and equipment can injure.
D Do not touch or handle induction head/coil during operation.
DDo not touch hot parts
DAllow cooling period before handling parts or equipment.
DKeep metal jewelry and other metal personal items away from head/coil during operation.
FALLING UNIT can cause injury.
DUse handle and have person of adequate physical strength lift unit.
DMove unit with hand cart or similar device.
DFor units without a handle, use equipment of adequate capacity to lift unit.
DWhen using lift forks to move unit, be sure forks are long enough to extend beyond opposite side of unit.
FLYING METAL OR ADHESIVE can injure eyes.
DWear approved safety glasses with side shields or wear face shield.
MOVING PARTS can cause injury.
D Keep away from moving parts such as fans.
D Keep all doors, panels, covers, and guards closed and securely in place.
STATIC (ESD) can damage PC boards.
DPut on grounded wrist strap BEFORE handling
boards or parts.
D Use proper
H.F. RADIATION can cause interference.
D
DHave only qualified person familiar with electronic equipment per- form this installation.
DThe user is responsible for having a qualified electrician promptly correct any interference problem resulting from the installation.
DIf notified by the FCC about interference, stop using the equip- ment at once.
DHave the installation regularly checked and maintained.
DKeep
MAGNETIC FIELDS can affect pacemakers.
DPacemaker wearers keep away.
DWearers should consult their doctor before going near induction heating operations.
OVERUSE can cause OVERHEATING
DAllow cooling period.
DReduce output or reduce duty cycle before starting to heat again.
DFollow rated duty cycle.
READ INSTRUCTIONS.
DRead Owner’s Manual before using or servic- ing unit.
DUse only genuine Miller/Hobart replacement parts.
1-4. California Proposition 65 Warnings
YWelding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
YBattery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
For Gasoline Engines:
YEngine exhaust contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
For Diesel Engines:
YDiesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and oth- er reproductive harm.
1-5. Principal Safety Standards
Safety in Welding, Cutting, and Allied Processes, ANSI Standard Z49.1, from Global Engineering Documents (phone:
Safety and Health Standards, OSHA 29 CFR 1910, from Superintendent of Documents, U.S. Government Printing Office, Washington, D.C. 20402.
National Electrical Code, NFPA Standard 70, from National Fire Protec- tion Association, Batterymarch Park, Quincy, MA 02269.
Canadian Electrical Code Part 1, CSA Standard C22.1, from Canadian Standards Association, Standards Sales, 178 Rexdale Boulevard,Rex- dale, Ontario, Canada M9W 1R3.
Practice For Occupational And Educational Eye And Face Protection, ANSI Standard Z87.1, from American National Standards Institute, 11 West 42nd Street, New York, NY 10036−8002 (phone: 212−642−4900, website: www.ansi.org).
