Miller Electric OM-1313 manual Installing Work Clamp, Installing Gas Supply

2-5. Installing Work Clamp

4

5

1 Work Cable

2 Boot

Slide boot onto work cable. Route cable out front panel opening from inside.

3 Negative (–) Output Terminal

Connect cable to terminal and cover connection with boot.

4 Hardware

5 Work Clamp

Route cable through clamp handle

	1	and secure as shown.
2
		Close door.

Tools Needed:

3

1/2, 3/4 in

ST-801 566-A

2-6. Installing Gas Supply

Tools Needed:

5/8, 1-1/8 in

		Obtain gas cylinder and chain to
	1	running gear, wall, or other station-
		ary support so cylinder cannot fall
		and break off valve.
		1	Cap
	2	2	Cylinder Valve
		Remove cap, stand to side of valve,
		and open valve slightly. Gas flow
		blows dust and dirt from valve.
		Close valve.
	3	3	Cylinder
		4	Regulator/Flowmeter
4		Install so face is vertical.
		5	Regulator/Flowmeter Gas
	Argon Gas		Hose Connection
		6	Welding Power Source Gas
			Hose Connection
		Connect customer		supplied	gas
OR		hose between regulator/flowmeter
	1	gas hose connection, and fitting on
		rear of welding power source.
7		7	Flow Adjust
5		Typical flow rate is 20 cfh (cubic feet
	2	per hour). Check wire manufactur-
		er’s recommended flow rate.
		8	CO2 Adapter (Customer Sup-
			plied)
	3	9	O-Ring (Customer Supplied)
8	9	Install adapter with O-ring between
		regulator/flowmeter		and	CO2
6	CO2 Gas	cylinder.

ST-801 571 / ST-802 028

OM-1313 Page 7