External view |
| External view |
........ | Number of items | . ... .. Number of items |
|
| .4 |
|
| .4 |
01
A The use of any accessows except for those provided might result in damage to the unit Make sure only to use the accessories shipped wth the unit, as shown above
Installation Procedure
1.To prevent a short circuit, remove the key from the rgnrtion and disconnect the (2) battery.
2.Make the proper Input and output wrre connectrons for each unrt.
3.Connect the speaker wires of the wrnng harness.
4Connect the wrnng harness wires In the followrng order: ground, battery, rgnrtron.
5.Connect the wiring harness connector to the unrt.
6.Install the unit In your car.
7.Reconnect the @ battery.
8.Press the reset button.
If you connect the ignitron wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that In turn may start a fire. Always connect those wires to the power source running through the fuse box.
Ir7iciGq
l If your car’s ignition does not have an ACC posrtron, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the rgnitron wire to a power source with a constant voltage supply, as with battery wires, the battery may die.
l If the console has a lid, make sure to Install the unit so that the faceplate will not hit the lid when closing and opening.
l If the fuse blows, first make sure the wires aren’t touchrng to cause a short crrcuit, then replace the old fuse with one with the same rating
l Insulate unconnected wires wrth vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.
l Connect the speaker wires correctly to the terminals to whrch they correspond. The unrt may be damaged or fail to work if you share the 0 wires or ground them to any metal part In the car.
l When only two speakers are being connected to the system, connect the connectors erther to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, If you connect the @ connector of the left speaker to a front output terminal, do not connect the @ connector to a rear output terminal
l After the unit IS Installed, check whether the brake lamps, blrnkers, wrpers, etc. on the car are workrng properly.
l Mount the unit so that the mountrng angle IS 30” or less.
- 17 -
