W Removing the hard rubber frame
1 Engage the catch pins on the removal tool and remove the two locks on the lower level.
Lower the frame and pull it forward as shown In the figure.
Accessory@
Removal tool
2 When the lower level is removed, remove the upper two locations.
W Removing the Unit
1 Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.
2Remove the screw CM4 x 8) on the back panel.
3Insert the two removal tools deeply into the slots on each side, as shown
Screw (M4X8) | Accessory@ | |
Reywal tool | ||
|
(commercrally avarIable
4Lower the removal tool toward the bottom, and pull out the unit halfway whrle pressing towards the Inside.
Be careful to avoid ~n]ury from
Athe catch pns on the removal tool
5 Pull the unrt all the way out wrth your hands, being careful not to drop it
@The frame can be removed from the top side in the same mannel
- 20 -
