piiiaKE
To prevent injury or fire, take the following precautions:
lInsert the unrt all the way In untrl It is fully locked in place. Otherwise it may fall out of place when jolted.
l When extending the ignition, battery, or ground wares, make sure to use automotive- grade wires or other wires with a 0.75mm’ (AWG18) or more to prevent wrre deterioratron and damage to the wrre coating.
l To prevent a short circuit, never put or leave any metallrc objects (such as coins or metal tools) Inside the unit.
l If the unit starts to emit smoke or strange smells, turn off the power immedrately and consult your Kenwood dealer.
l Make sure not to get your fingers caught between the faceplate and the unit.
lBe careful not to drop the unrt or subject It to strong shock
The unit may break or crack because It contarns glass parts.
l Do not touch the liquid crystal flurd if the LCD IS damaged or broken due to shock. The liquid crystal fluid may be dangerous to your health or even fatal.
If the liquid crystal flurd from the LCD contacts your body or clothrng, wash It off with soap immediately
piii%Eq
To prevent damage to the machine, take the following precautions:
lMake sure to ground the unit to a negatrve 12V DC power supply.
l Do not open the top or bottom covers of the unit.
l Do not install the unit In a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possrbilrty of water splashing.
l Do not set the removed faceplate or the faceplate case in areas exposed to direct sunlight, excessive heat or humrdrty. Also avoid places with too much dust or the possibility of water splashing
l To prevent deterioration, do not touch the terminals of the unit or faceplate with your fingers.
l Do not subject the faceplate to excessrve shock, as it is a piece of precrsron equipment.
l When replacing a fuse, only use a new one with the prescrrbed rating. Usrng a fuse with the wrong rating may cause your unit to malfunction.
0 To prevent a short clrcurt when replacing a fuse, first disconnect the wrring harness.
l Do not place any object between the faceplate and the unrt.
l Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit.
IMPORTANT INFORMATION
About the disc changer to be connected:
To connect a disc changer having the
A disc changer doesn’t work when It IS connected without using these options.
If a model with no
Note that none of the
A | You can damage both your unit and the CD | |
changer If you connect them rncorrectly | ||
|
Do Not Load 3-in. CDs in the CD slot
If you try to load a 3 in. CD wrth Its adapter into the unit, the adapter might separate from the CD and damage the unrt.
