Miller Electric OM-227 398D manual Threading Welding Wire Through XR-Control Feeder

4-5. Threading Welding Wire Through XR-Control Feeder

	1	Cable Assembly
	Lay cable assembly out straight.
Tools Needed:	2	Jog Switch
	Push Jog switch up to feed wire through
2	cable assembly.

1

Ref. 802 193-A

4-6. Adjusting Tension At Feeder

	. Hold wire tightly to keep
Tools Needed:
	it from unraveling.

6 in (150 mm)

Open tension arm. Pull and hold wire; cut off end.

Proceed to Section 4-9.

Thread wire thru inlet guide, along drive roll groove, and into wire conduit. Close tension arm. Adjust tension as follows: grasp spool with one hand, press Jog switch, and turn thumb nut clockwise until motor stalls when Jog switch is pressed. Back thumb nut off slightly.

Ref. 802 193-A

OM-227 398 Page 10