5-8. Replacing The Gun Liner On XR-Aluma-Pro Guns
1 | 4 | 2 | 3 |
Gun End
.Refer To Instructions Below.
Remove Old Liner (Item 2) From Gun End
Install New Liner (Item 2) Into Gun End
5 | 6 | 2 | 7 |
.Gently pry open
slots to remove wire collet guide.
. Cut liner flush with wire collet guide.
Power Pin End
Ref. 804
!Turn Off welding power source and wire feeder.
1Leather Cover
2Liner
3Liner Lock Allen Screw
4Liner Guide Reducer
5Wire Guide Cone
6Wire Collet Guide
7Power Pin
Lay gun cable out straight.
Remove short leather cover to access liner assembly.
Loosen liner lock allen screw (located near back of handle) to remove liner guide re- ducer from gun.
Remove wire guide cone and wire collet guide from power pin.
Remove old liner from gun end (see il- lustration above).
Insert new liner into gun end and continue feeding liner through cable assembly until
liner is through power pin assembly and is visible.
Install liner assembly into gun and tighten liner lock allen screw.
Reinstall wire collet guide at power pin and tighten onto liner.
Cut liner off flush with wire collet guide. Re- install wire guide cone.
Refer to Owner’s Manual for instructions on rethreading wire.
