Miller Electric OM-234 016D manual Controls For Renegade 180 Model

4-3. Controls For Renegade 180 Model

A. Spool Gun Operation On Renegade 180 Model

		. Spool Gun/MIG Gun switch on
			Renegade 180 must be in
			Spool Gun position for spool
	2		gun to operate.
		1	Shielding Gas Cylinder
	1	For shielding gas connections, see
		welding		power	source Owner’s
		Manual.
		2	Valve
		Open valve on cylinder just before
		welding.
		Close valve on cylinder when
		finished welding.
		3 Spool Gun/MIG Gun Switch
	3	Place switch in Spool Gun position.
		4	Trigger
		Press trigger to energize welding
		power		source	contactor, start
		shielding gas flow, and begin wire
		feed.
		5 Wire Feed Speed Control
		Wire feed speed is controlled by
		welding power source Wire Speed
		control (see welding power source
		Owner’s		Manual	for appropriate
		setting).
		6	Voltage Control
		Arc voltage is controlled by welding
		power source Voltage control (see
		welding		power	source Owner’s
		Manual for appropriate setting).
		. To purge shielding gas line, set
			gun selection switch (item 3) to
			the MIG Gun position. Press
			spool gun trigger to energize
			gas valve. Shielding gas will
			flow, but spool gun will not feed
6	5		wire. Hold trigger in for several
			seconds to purge gas line.
			Return gun selection switch to
			the Spool Gun position before
			welding.

4

sb5.1* 6/92 − S-0621-C / Ref. 804 755-B / Ref. 804 986-A / 804 476-C

OM-234 016 Page 28