Miller Electric PipePro 304 manual CT1

Trouble	Remedy
Engine does not go to low (idle) speed	Be sure Engine Control switch S2 is in Run/Idle position.
with Engine Control switch in Run/Idle
position.
	Remove all weld and generator power loads.
	Turn off remote device connected to Remote 14 receptacle RC14 (see Section 5-8).
	Check for obstructed movement of throttle solenoid linkage.
	Have Factory Authorized Service Agent check voltage regulator board PC8 and current transformer
	CT1.
Engine does not go to high (run) speed	Place Engine Control switch in the Run position. Have Factory Authorized Service Agent check unit.
when generator power or large weld
load is applied with Engine Control
switch in Run/Idle position.
Engine uses oil during run-in period;	Dry engine (see Section 10 and engine manual).
wetstacking occurs.
Coolant recovery tank continuously	Bleed air from radiator, and replace lost coolant (see Section 5-3).
overflows.

Notes

OM-492 Page 44