Install
the
Air
Conditioner
in
the
Case
1.Slide the air conditioner into the case. Reinstall the 2 screws removed earlier on each side of the case.
5.Attach the front grille to the case by inserting the tabs on the grille into the slots on the front of the case. Push the grille in until it snaps into place.
Screw 
Power Cord 
Screw
CAUTION: The power cord must be connected to an independent circuit. The green wire must be grounded.
2.Stuff the foam between the top of the unit and the wall to prevent air and insects from getting into the room.
The Foam
3. Before installing the front grille, pull out the vent control lever located above the unit control knobs, as shown.
When you detach the front grille 
from the case, push the grille to 
your right side and pull it toward 
you. 
6.Lift the inlet grill and secure the front grille with a screw. Lower the inlet grille into place.
Use the
Reversible
Inlet
Grille
1. If you want to pull out the filter upward, open the inlet grille slightly. Turn inside out the front grille.
Disassemble the inlet grille from the front grille with separating the hinged part by inserting a "— " type
Rotate the inlet grille 180 degrees and insert the hooks into the lower holes of front grille.
Then, insert the filter
2. If you want to pull out the filter downward, use the reversible inlet grille without change.(The grille is already assembled for that way.)
16
