RU760.qxd 04-06-2004 16:59 Pagina 6

English

Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device, the remote control can automatically search for the right code.

Example of TV:

1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).

The RU760 emits the ‘switch off TV’ signal for all models of TV that are

stored in the memory.

If the device is a DVD-player or VCR, insert a disk or tape and start playback.

2Keep the LEARN key pressed for 5 seconds, until the green light around the Standby key blinks twice and then remains lit.

3Press the Standby key of the RU760 briefly.

VCR DVD SAT AMP CD

LEARN SELECT GUIDE

TITLE

AUDIO CHAPTER SUBTITLE

DISCSYST.MENU

VCR DVD SAT AMP CD

LEARN SELECT GUIDE

The RU760 now starts emitting all known ‘TV off ’ signals, one by one.

Each time a code is sent, the green light around the Standby key lights up.

4When your TV switches off (standby), press the Standby key of the RU760 immediately to confirm.

The RU760 has now found a code that works on your TV.

VCR DVD SAT AMP CD

LEARN SELECT GUIDE

VCR DVD SAT AMP CD

LEARN SELECT GUIDE

5 Check if you can operate all functions on your TV with the RU760.

If this is not the case, you can redo the automatic setting.The RU760 will then search for a code that perhaps works better.

After the RU760 has run through all the known codes, the search will stop automatically and the green light will stop blinking.

Automatic programming of a TV takes a maximum of 3 minutes.

6

Page 6
Image 6
Mintek SBC RU760 manual Automatically setting the remote control, Press the Standby key of the RU760 briefly