Mirage Loudspeakers Prestige S8, Prestige S10 Terminology And Controls, o w n e r s m a n u a l

PHASE – This switch allows for the adjustment of the phase of the subwoofer, in relation to the speakers used in your system, from -180 to +180 degrees.

o w n e r s m a n u a l

CAUTION: The included spike feet could damage hard surface floorings if used incorrectly.

TERMINOLOGY AND CONTROLS

e STATUS INDICATOR – The LED found on the front panel will illuminate in blue when the subwoofer is functioning. If the unit is in Auto mode and is not receiving a signal, the light will remain off.

r SPEAKER LEVEL IN – The Speaker Level inputs are designed to be used on receivers or amplifiers that do not incorporate any RCA type subwoofer outputs. If your receiver is equipped with an RCA type subwoofer output, these speaker level inputs should not be utilized.

tLINE IN/SUB IN – These inputs are an RCA type LFE/stereo/mono input. If you are connecting your subwoofer to a pre-amp/processor with a LFE or

Subwoofer pre-amp output, connect a single RCA cable to the LFE/Left input.

u CROSSOVER MODE – This switch allows for the selection of either crossover Activated or Crossover Bypassed. (Please see the connections section for suggestions on which mode is appropriate for your installation.)

i LOW-PASS FILTER – This control allows for the adjustment of the low-pass filter. Adjustments can infinitely be made from 40Hz to 120Hz. This will determine the highest frequency that the subwoofer will reproduce.

o

p VOLUME LEVEL – This knob can be adjusted to control the level of output from your subwoofer. The level chosen should allow the subwoofer to blend its output with that of the rest of your audio system.

a POWER MODE – This switch can be set to either On, Off or Auto. If the switch is in the Off position, the subwoofer will not power up. If the switch is in the On position, it will constantly remain on. If the switch is set to the Auto position, when a signal is present the subwoofer will turn on and will automatically turn off several minutes after a signal is no longer present.

sPOWER CORD CONNECTOR – Connect the power cord from your AC outlet to this input. Connecting your subwoofer to a surge protector or line conditioner is always recommended. Do not connect the power cord to the switched or unswitched outlet of your receiver as this could damage your subwoofer and receiver.

3