Mitsubishi Electronics 838 STATUS Indicator, Setting Up and Using TV, Using the ANT Antenna Input

1. Basic Setup and Operation 7

The	STATUS Indicator
Key	O	Off	@	Steady On
	O	Slow Blinking	Q	Fast Blinking

None O TVis powered off, Norma) operation.

Green O TVis powered on, Norma) operation.

Green	Tv powered off,		auto-on	TV Timer is
	set,
	Norma) operation. TV can be turned on
	at any time.
Green	TV just	powered	off and	mampis
	cooling.
	Sixty seconds after turning off TV, LED
	wiU start to bunk. TV can be turned back
	on before bunking starts or after bunk-
	ing stops, but not whUe the indicator is
	bunking.	Norma)operation.
	TV is too hot. The TV wUIdisplay a

warning message and shut off if it over- heats.

oAmbient room temperature may be too high. Turn off the TV and let the

room temperature drop.

Clear blocked air vents. Ensure at least a four-inch clearance on all sides of the TV.

Yellow	Lamp	access		door is not secure	or	no
	(amp	installed.
	TV wiU not operate until lamp access
	door is secured. See Appendix A.
Red	Lamp	faimureo Replace the lamp.			See
	Appendix		A.
Red/ _D	TV may		require	service.
Yellow	* Hold		power	button on front panel		for
	10 seconds to reset TV.

*If LED continues to flash red and yellow after reset, turn off the TV and unplug it from the AC power source. Wait one minute and then plug the set back in.

If LED continues to flash red and yellow, go to www.mitsubishi-tv.com or call 1-800-332-2119 to receive Authorized Service Center informa- tion.

You may be asked to count how many times the LED flashes each color to aid in troubleshooting.

Setting Up and Using TV

Using the ANT (Antenna} Input

If using an antenna or direct cable service (no cable box), connect the incoming coaxial cable to the TV's ANT input. Refer to page 12.

You must perform a channem scan to enabme recep- tion of digitam channemso mfyou skip this step, the TV will receive onmyanamog channems. The channel scan will search for high-definition and standard-definition channels avaUable in the local area.

Memorizing Channels with ChanneY Sca n For the ANT input

To start channem memorization 1, Power on the TV.

Press MENUand open the Setup > Channel menu.

First press V to navigate to the Setup icon, then use _ to highlight the Channel icon.

Start channel memorization from the Setup > Channel menu.

°Press V to enter the menu.

4° Highlight Ant Air if connected to an

over-the-air antenna. Highlight Ant Cabmefor service over direct cable

(no cable box). Press ENTERto add a check.

For first-time setup, highlight AH channems. To scan for channels not already in memory, highlight New onmy. Press ENTERto add a check.

Highlight Scan and press ENTER. Channel memorization may take up to 15 minutes to complete.

To stop channem memorization before compmetion, press CANCEL.

For assistance ca((1(800} 332-2119