Mitsubishi Electronics CP900DW operation manual Connections, Setting Mode Switches

CONNECTIONS

SETTING MODE SWITCHES

SETTING MODE SWITCHES

Set the mode switches on the rear panel according to the equipment connected. All the switches are set to OFF as shown right when shipped from the factory. Turn off the power when changing the mode switch settings.

With the switch No.1 and No. 2, the printing speed can be set.

Switch No.		Print speed
1	2
OFF	OFF	Prints at the speed set by the printer driver
ON	ON
OFF	ON	FINE mode print
ON	OFF	FAST mode print

With the switch No.3 to No. 8, the following can be set.

8 7 6 5 4 3 2 1

OFF

ON

Switch No.	Settings	Functions
3	OFF	Uses the normal gamma curve of images
	ON	Uses the gamma curve for connecting to ultrasound diagnostic equipment
4	OFF	Normal print
	ON	Mirror print
5	OFF	Prints with surface coating
	ON	Prints without surface coating
6	OFF	Not used (Set this switch to OFF.)
7	OFF	When the printed paper remains at the print outlet, PAPER indicator blinks and this unit stops printing.
	ON	Even if the printed paper remains at the print outlet, PAPER indicator remains turned off and this unit
		does not stop printing.
8	OFF	Automatic feed&cut mode
		This will cause the printer to perform an automatic feed and cut after installation of the paper and ink
		sheet.
	ON	Manual feed&cut mode

10