Preparing your projector

What’s included in the box

AC power cord

for US J2552-0063-03

1

Remote control

 

for EU J2552-0066-02

1

User Manual/Quick Start up (English only)

 

for UK J2552-0065-02

1

Safety Manual/Quick Start up

1 RGB cable for PC

J2552-0072-05

1

CD-ROM (with User Manual)

 

 

2

Battery

 

 

1

Lens cap

 

 

1

Lamp replacement attachment

Important:

The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1

1.

Remove the back lid of the remote control.

.

Check the polarity (+), (-) of the batteries, and set them

 

3

correctly, inserting their (-) side first.

 

 

• If the battery is inserted from the (+) side first, inserting

 

 

the (-) side is difficult because the coil spring end hits

 

 

on the battery side. If the battery is forced in this way,

 

2

the outer label of the battery may get ripped and it may

 

cause a short-circuit and heating.

 

 

 

. Attach the back lid.

 

Important:

 

 

• Use two size-AA batteries (R6).

 

 

• Replace the two batteries with new ones when the

 

 

remote control is slow to respond.

Removing the batteries from the remote control

Remove the back lid of the remote control and take out the batteries.

Caution:

Use of a battery of wrong type may cause explosion.

Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

Dispose of used batteries according to your local regulations.

Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.

Be sure to handle the batteries according to the instructions.

Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

Keep batteries out of reach of children and pets.

Remove the batteries, if the remote control is not used for a long time.

Do not combine a new battery with an old one.

If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-

Page 6
Image 6
Mitsubishi Electronics HC4000 user manual Preparing your projector, What’s included in the box