Mitsubishi Electronics HS-U448 manual Editing Features, Using Two VCRs to Copy

Editing Features

Using Two VCRs to Copy

There are two basic ways to make a copy of a tape.

One way is to use the HS-U448 to record and another VCR for playback.

The other way is to use another VCR to record and use the HS-U448 for playback.

Regardless of which method you may choose, you will need one RCA audio cable and one RCA video cable to connect the two VCRs. If you do not have these cables, they are available at your local electronics dealer.

Using the HS-U448 to record from another VCR

1Connect the audio cable to AUDIO OUT L and R on the playback VCR and to AUDIO IN L and R on the HS-U448. If the playback VCR is mono, use only the AUDIO IN L on the HS-U448.

2Connect a video cable to VIDEO OUT on the playback VCR and to the VIDEO IN on the HS-U448.

3If the playback VCR is Hi-Fi, set the audio monitor to Stereo.

4Use INPUT to set the HS-U448 to External L1 if you used the HS-U448 rear panel jacks, or External L2 if you used the HS- U448 front panel jacks.

5Put a blank tape into the HS-U448.

6Put the tape you want to copy into the playback VCR and find the cue point. Press STOP if the picture starts playing.

7On the HS-U448, press REC, then PAUSE.

8On the playback VCR, press PLAY, then

PAUSE.

9Press the PAUSE buttons on both VCRs at the same time to begin copying the tape.

10When finished, press STOP on both VCRs.

HS-U448	RECORDING	PLAYBACK
VIDEO IN L/MONO - AUDIO IN - R
L R	AUDIO IN 2 R	AUDIO OUT L	L	R
VIDEO	AUDIO IN 2 L/MONO	AUDIO OUT R		VIDEO OUT
IN 2

30