Mitsubishi Electronics LCD1720M manual Quick Start -continued, Tilt and swivel

Figure R.1

Quick Start –continued

Tilt and swivel

Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS.1).

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:

1. Disconnect all cables.	Figure TS.1
2. Place monitor face down on a
non-abrasive surface. Insert a

screw driver (or similar object)

into the hole on the bottom of stand. As shown in the picture, hold the stand cover in hand and lift up gradually by the stick and

then remove (Figure R.1).

3. Remove the 4 screws connecting the monitor to the

stand and lift off the stand assembly (Figure R.2).

The monitor is now ready for mounting in an alternate manner.

4.Connect the AC cord, signal cable and Audio cable to the back of the monitor (Figure R.3).

5.Reverse this process to reattach stand.

NOTE: Use only VESA-compatible alternative mounting method.

Figure R.2

Figure R.3

Non-abrasive surface

6