Mitsubishi Electronics MSH24WN Maintenance, When it is not going to be used for a long time

Models: MSH24WN

1 32
Download 32 pages 5.54 Kb
Page 11
Image 11

WHEN THE AIR CONDITIONER IS NOT GOING TO BE USED FOR A LONG TIME

MAINTENANCE

When it is not going to be used for a long time:

1Perform the FAN operation for 3 or 4 hours to dry the inside of the air conditioner.

To perform FAN operation, set the remote controller to the highest temperature in the MANUAL COOL mode. (Refer to page 8.)

” “Cool

Manual

operation

When the air conditioner is to be used again:

1Clean the air filter and install it in the in- door unit.

(Refer to page 12 for cleaning instructions.)

Clean the filter before installing.

Before starting maintenance

Turn off the breaker.

CAUTION

When the unit is to be cleaned, switch it off and turn off the breaker. Since the fan rotates at high speed during operation, it may cause an injury.

Cleaning the indoor unit

Clean the unit using a soft dry cloth.

Do not use gasoline, benzine, polishing powder, or in- secticide. The unit may be damaged.

2Turn off the breaker.

CAUTION

Turn off the breaker when the air conditioner is not going to be used for a long time.

Dirt may collect and this may cause a fire.

3Removetroller. the batteries from the remote con-

CAUTION

To prevent liquid leakage, take out all batteries when the remote controller is not going to be used for a long time.

2Check that the air inlet and outlet of the indoor/outdoor units are not blocked.

3Check that the ground is connected correctly.

CAUTION

Ground the unit.

Do not connect the ground to a gas pipe, water pipe, lightning rod or the ground of a telephone. If the ground- ing is incorrect, it may cause an electric shock.

CAUTION

Do not open the front panel up past the level position.

The panel may come off in order to prevent it from being damaged.

The front panel may also come off if the upper part of the front panel is pulled down.

Do not exceed.

Movable range

If the front panel comes off, attach it as explained below.

Keeping the front panel level with one hand, insert the hinges one by one with the other

 

hand into the notches at the left, right and center of the top of the indoor unit until they click

 

into place. (1) Then, close the front panel. (2)

 

1

 

Keep the front panel level and

 

 

 

 

 

 

 

 

insert the hinges into the notches.

2

Do not step onto an unstable bench when maintaining the unit, etc. This may cause an injury, etc. if you fall down.

11

Page 11
Image 11
Mitsubishi Electronics MSH24WN Maintenance, When it is not going to be used for a long time, Before starting maintenance