P C L 5 1 0 0 f e a t u r e s a n d u p g r a d e s

18.Reconnect the fan-sink’s power cable to the motherboard. It goes on the connector labelled FAN 2 or PL200 as shown on the motherboard diagram.

CAUTION

If the fan-sink power cable is not reconnected properly the processor may overheat and be permanently damaged.

19.Adjust the processor voltage and bus speed selection jumpers in block PL19 as described at the start of this chapter.

When you have finished, replace any expansion cards you needed to remove, then refit the system covers.

Replacing the configuration battery

The computer keeps a record of its current hardware configuration in a CMOS memory chip which is sustained by a small battery. This battery has a life of up to 5 years. If you find that you have to reconfigure the computer every time you turn it on, the battery is probably failing and needs to be replaced.

The battery is a 3 volt lithium type (CR2032 or equivalent) typically used in calculators and other small, battery-powered electronic items.

PCL5100 USER GUIDE 13