Mitsubishi Electronics PCL5100 PL3, PL11, PL11, PL201, Clearing CMOS, BIOS reprogramming, Power Mode light colour (PL201), BIOS upgrade and recovery (PL11, PL3)

P C L 5 1 0 0 f e a t u r e s a n d u p g r a d e s

BIOS upgrade and recovery (PL11, PL3)

These jumpers should not normally be changed except by a service engineer or at the direction of a service engineer.

CMOS is cleared by moving the PL11 jumper to the 2-3 position for a few moments while the system is turned off, then returning it to the normal 1-2 position.

Clearing CMOS	PL11
CMOS battery connected (default)	1-2
CMOS battery disconnected	2-3
BIOS reprogramming	PL3
Enabled (default)	1-2	(PROG)
Disabled	2-3	(DIS)

Power Mode light colour (PL201)

Normally, the Power Mode light is [red] when the system is in Off mode. If you move the jumper on block PL201 to pins 2-3 (OFF) the light is extinguished in Off mode.

PCL5100 USER GUIDE 5