Mitsubishi Electronics V51LCD, V91LCD, V71LCD manual Removing the Base, Connecting a Flexible Arm

Quick Start –continued

Removing the Base

Note: Always remove the Base when shipping the

LCD.

1. Place monitor face down on a non-abrasive surface.

2.While using your thumbs, press the tabs in the direction of the arrows to unlock the stand.

3.Pull the unlocked base off the stand.

Connecting a Flexible Arm

This LCD monitor is designed for use with a flexible arm. Please use the attached screws (4pcs) as shown in the picture when installing.

To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.

The LCD monitor should only be used with an approved arm (e.g. GS mark).

Replace screwsThickness of

Bracket (Arm) 2.0~3.2 mm

Tighten all screws.

75 mm (V51LCD)

100 mm (V71LCD)

100 mm (V91LCD)

Specifications

4-SCREWS (M4) (MAX depth: 8.5 mm)

If using other screws, check depth of holes.

75 mm (V51LCD)

100 mm (V71LCD)

100 mm (V91LCD)

Weight of LCD assembly:

2.8kg - V51LCD (MAX)

4.2kg - V71LCD (MAX)

5.5kg - V91LCD (MAX)

6

DP51V71V91VManual112304.p65 6 11/29/04, 3:36 PM