Mitsubishi Electronics WD-52528, WD-62527 Adjustment Selection, Adjusting Data, Saving Data

MODEL: WD-52527 / WD-52528 / WD-62527 / WD-62528

4. Adjustment Selection

Use the “VIDEO” button to select a specific elecrtrical ajustment, “1 HPOS” or “2 VPOS”.

5. Adjusting Data

After selecting an adjustment item, use the “UP” and “DN” buttons to change adjustment data.

•If the “UP” button is pressed, the adjustment data increases.

•If the “DN” button is pressed, the adjustment data decreases.

6.Saving Data

Press “ENTER” to save the adjustment data in memory.

The display characters go red for approximately one second in this step.

Note: If the circuit adjustment mode is terminated without pressing “ENTER”, changes in adjustment data are not saved.

7. Terminating the circuit adjustment mode

Press the “MENU” button on the remote hand unit twice to terminate the adjustment mode.

Note: The adjustment mode can be also terminated by turning the power off.

Transferring Data

1)Enter the Service Adjustment Mode ... Press “MENU-2-4-5-7”

2)Press “0” when in the Service Mode ... Three choices appear at the top of the screen.

Data Transfer	"MENU-2-4-5-7-0"
Display	Description
Restore Back Up	Resets data to factory values
Upload Terminal Data	Not used
Down load WB data to FMT	Use after replacing Engine PWB-FORMAT

3) Use the UP & DN keys to highlight the desired choice, the Press “ENTER”

Page 29