Mitsubishi Electronics WS - 55313 manual Connecting a DTV Receiver, DTV Connectors and Adaptors

Connecting a DTV Receiver

Note: The TV back panel and connections shown here are for reference only and may vary by model.

DTV Connectors and Adaptors

(Figure 11)

The TV back panel has five RCA-type connectors for the DTV connection. The back panel of your DTV receiver may use RCA-type connectors or BNC-type connectors. If your DTV receiver comes with BNC type connections, you will need to purchase BNC to RCA adaptors to connect the TV to the DTV receiver. These adaptors should be available at most electronic supply stores.

			or
BNC to		Adaptor	RCA
RCA	BNC	Fitted to	Connector
Adaptor	Connector	Connection

Figure 11. DTV connectors and adaptors.

DTV Receiver with Component Video Connections (Recommended)

(Figure 12)

1.Connect the outside antenna cable, or satellite to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver owner’s guide for instructions and cable compatibility).

See Appendix B, page 65 for component video signal compatibility information.

For digital audio connections, see your DTV receiver and A/V receiver Owner’s Guides.

TV Back Panel (section detail)

2.If your DTV receiver has a built-in terrestrial tuner, connect the incoming terrestrial antenna to ANT on the DTV receiver. If your DTV receiver does not have a built-in terrestrial tuner, this TV will only be able to provide an analog signal through Ant-A on the TV back panel.

					COMPONENT			DTV(YPbPr/ GBRHV )
					480 i / 480P/ 1080i			480i / 480P /1080 i
					1	2
Incoming Antenna,	MONITOR		I N P U T
	OUT	1	2	Y
or Cable.					Y	3	G
				G			Y
				Pb		3
				S-VIDEO	H		Pb		H
				B			B
					Pb
2				P r	V	3	P r		V
				V IRD EO			R
					P r
				AUDIO-	AUDIO -			4	White
				LEFT /	L E FT /
				(MONO)

RIGHT	AUDIO -	4	Red
AUDIO-
	RIGHT

AN T - A	LOO P	AN T- B
	OUT

2

3.Connect the RCA-type cables from the DTV receiver outputs to DTV INPUT Y/Pb/Pr on the TV back panel. You may need to set the DTV Input Assignment to Y/Pb/Pr (see page 35).

4.Connect the L (left) and R (right) audio cables from the DTV receiver to DTV AUDIO on the TV back panel.

5.To utilize the benefits of a digital A/V receiver, connect your DTV receiver’s digital audio out to a digital input on your digital A/V receiver.

Component (1 and 2) may also be used for 1080i components.

DTV Receiver (with component video connections)

			CAUTION
			RISK OF ELECTRICAL SHOCK
AUDIO	AUDIO	White	DO NOT OPEN

3	Y	L	L	4
				VCR
				CONTROL	OUT TO TV

3				4		CH 3
	Pr	R	R			CH 4
					Red	DIGITAL
RF						AUDIO OUT
3	Pb
		V IDEO	V IDEO
PHONE JACK REMOTE				S-VIDEO		IN FROM ANT	SATELLITE IN

or 1

to antenna, cable or satellite

1

Figure 12. Connecting the DTV receiver with component Video Connections.

19