Mitsubishi Electronics X500U user manual Basic connections, Projector + AV equipment

Basic connections

This projector can be connected to equipment such as VCRs, video cameras, videodisc players, and personal com- puters having analog RGB output.

Important:

•Make sure that your equipment is turned off before connection.

•Plug in firmly and unplug by holding the plug, not by pulling the main power cable.

•If connected units are set too close to one another, the image may be affected.

•Refer to the owner's guide of each component for details of connections.

Projector + AV equipment

Important:

•Match the color of video and audio plugs on the AV cable with the connections.

•S-video signals take priority over video signals. If you input both S-video signals and normal video signals at the same time, the normal video input automatically is inhibited.

	INPUT SELECT	COMPUTER 1 IN	AUDIO 1 IN	RS-232C	USB
REMOTE				VIDEO 1 IN VIDEO 2 IN
	DIGITAL
	ANALOG
MAIN		COMPUTER 2 IN	AUDIO 2 IN	S-VIDEO
				VIDEO
O	I
	AC IN	COMPUTER OUT	AUDIO OUT	L

AUDIO

R

VCR etc.

Connect either one of these.

to S-video input to video input

to audio input

to video output

to audio output

to S-video output

Projector + DVD player or HDTV decoder

Some DVD players have output terminal for 3 line fitting (Y, CB, CR). When connecting them to the projector, connect to COMPUTER 1 IN or COMPUTER 2 IN of the projector.

DVD player or HDTV decoder

		AUDIO cable
		to COMPUTER
Y CB(PB) CR(PR)	to AUDIO OUT	AUDIO IN

BNC - RCA connector (optional)

No connection

G B R HD/CS VD

	INPUT SELECT	COMPUTER 1 IN	AUDIO 1 IN	RS-232C	USB
REMOTE				VIDEO 1 IN VIDEO 2 IN
	DIGITAL
	ANALOG
MAIN		COMPUTER 2 IN	AUDIO 2 IN	S-VIDEO
				VIDEO
O	I
	AC IN	COMPUTER OUT	AUDIO OUT	L

AUDIO

R

Mini D-SUB 15 pin-BNC conversion cable (optional)

to COMPUTER IN (Mini D-SUB 15P)

•Y, PB, PR is an example of the terminal names for a HDTV decoder.

•The terminal name is different depending on the connected equipment.

•Use mini D-SUB 15 pin-BNC conversion cable for connection.

•Some DVD players may not project the image correctly.

•When connecting with HDTV equipment which has R, G, B output, set RGB for the COMPUTER INPUT in the SIGNAL setting menu.

•Change the setting in the SIGNAL menu, when 525p signal is inputted. (Refer to page 29).

•Set the INPUT SELECT switch on the terminal board to ANALOG.

EN – 10