Menu operation (continued)
1 IMAGE
CONTRAST | Use to adjust the image contrast. The contrast |
| becomes higher as the value increases. |
BRIGHTNESS | Use to adjust the image brightness. The image |
| becomes brighter as the value increases. |
WHITE ENHANCE | Use to adjust the white level of the projected image. |
| Select AUTO for normal use. |
COLOR TEMP | Use to adjust the color temperature. See page 18. |
COLOR | Use to adjust the color intensity of the image. |
TINT | Use to adjust the color balance of the image. The |
| color balance shifts to green as the value increases |
| and shifts to purple as the value decreases. (Avail- |
| able only when VIDEO or |
| source.) |
opt.
IMAGE
CONTRAST
BRIGHTNESS
WHITE ENHANCE
COLOR TEMP.
COLOR
TINT
SHARPNESS
GAMMA MODE
XGA60
0
0
AUTO
STANDARD
0
0
0
AUTO
| • When the TV50 (PAL, SECAM) signal is input, TINT can’t be adjusted. |
SHARPNESS | Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not |
| available with certain signals.) |
GAMMA MODE | When AUTO is selected, the appropriate gamma mode is automatically selected depending on |
| the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select |
| STANDARD for sport scenes and video sources. Select THEATER for film sources. |
2 INSTALLATION
AUTO POWER ON | When ON is chosen, the lamp is automatically lit |
| when the power cord is plugged in the wall outlet. |
| Choose ON when using the projector mounted on the |
| ceiling. |
| • The projector is in the |
opt.
INSTALLATION
AUTO POWER
ON
AUTO POWER
OFF
XGA60
OFF
OFF
| lamp is off. Use the remote control to turn on the |
| lamp. |
AUTO POWER OFF | Use to set the time elapsed before the projector |
ON
SPLASH
SCREEN
BACK COLOR
ON
BLUE
| enters the |
| input from the source. |
SPLASH SCREEN | Choose ON to display the splash screen when the |
| power is turned on. |
LAMP MODE
IMAGE REVERSE
STANDARD
OFF
BACK COLOR | Use to select the background from among BLUE and BLACK, which will be displayed when there |
| is no signal input from the source. |
LAMP MODE | Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low |
| and the projector operating noise is reduced, resulting in a longer lamp replacement interval. |
| • When the lamp mode is switched, the projected image may flicker. This is not a product mal- |
| function. |
| • Do not change the setting of LAMP MODE frequently. |
| • When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW |
| about one minute after |
IMAGE REVERSE | Use to reverse the projected image. Select MIRROR for rear projection with the tabletop- |
| mounted projector. Select MIRROR INVERT for front projection with the |
| tor. |
