Mitsubishi Electronics XD110, SD110 user manual Indicators, Normal condition, Abnormal condition

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.

The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.

STATUS indicator POWER indicator

Normal condition

POWER	STATUS		CONDITION	NOTE
			Stand-by
Steady red		Off
			Lamp stand-by (about 1 minute)	The POWER button cannot be used to switch
Steady green	Blinking green			between on and off.
			The power is on. (Normal condition)
Steady green	Steady green

Abnormal condition

POWER		STATUS			CONDITION	POSSIBLE SOLUTION
Steady green					Abnormal temperature	• Clean the ventilation grilles.
	or	Blinking orange			• The ventilation grilles is clogged with dust or dirt.	• Relocate the projector to a cooler place.
					• The room temperature is high.
Steady red
						• Wait until the STATUS indicator goes out,
					The protection circuit is working or the lamp is in an	then press the POWER button.
Steady red		Blinking green			abnormal condition.	• If the above solution is not effective,
						replace the lamp.
					The lamp operation time exceeds the time elapsed until
Steady green		Blinking green/red			the lamp shutdown notice while the power is on. (See
					page 22.)
						Replace the lamp.
					The lamp operation time exceeds the time elapsed until
Steady red		Blinking red			the lamp shutdown notice while the power is off. (See	Change with a new lamp if this problem
					page 22.)	recurs.
					The lamp operation time exceeds the time elapsed until
Steady red		Steady red			the lamp shutdown. (See page 22.)
					The lamp cover isn’t closed.	Close the cover correctly.
Blinking green/red			Off
		Steady
Blinking green/red				or	Abnormal.	Contact your dealer.
		Blinking

EN-26