Advanced feature, Still, Connection | Mitsubishi Electronics XD110

Advanced feature

Still

To stop the motion in the image temporarily (or to display a still image):

Press the STILL button on the remote control.

• The image will freeze temporarily.

To resume the motion in the image:

Press the STILL button on the remote control again.

Important:

•Do not display a still picture for a long time because the afterimages may persist on the screen.

Page-up and page-down

You can control the computer to page-up and page-down the presentation data using the remote control. Switch the pages using the PAGE UP or DOWN button on the remote control.

Connection

To control the computer using the remote control, connect the projector with the computer as shown below.

USB

USB cable (option)

USB 4-pin

(type B)

to USB port

USB 4-pin

(type A)

•Only the computers equipped with a USB port are sup- ported.

•Wait for the lamp to light up before connecting the USB cable.

EN-20

Page 20

Image 20

Mitsubishi Electronics XD110 Advanced feature, Still, To resume the motion in the image, Page-up and page-down, Connection

Contents

Please read it before using your projector MODELThis User Manual is important to you ENGLISH When using the projector in Europe COMPLIANCE NOTICE CAUTION TO REDUCE THE RISK OF ELECTRICSHOCK DO NOT REMOVE COVER OR BACK NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL Contents Important safeguardsDeclaration of Conformity Trademark, Registered trademark Important safeguards Do not keep using the damaged projector Do not look into the lens when the projector is oper- atingDo not unplug the power cord during operation Do not look into the air outlet grilles when projector is operating Overview Control panelTerminal board 10 11 Remote control Bottom side Remote control Battery installationOperation range of the remote control Reception angle vertical Installation Layout of the projectorFront projection Front projection, ceiling mounting Projector + DVD player or HDTV decoder Basic connectionsProjector + AV device Projector + Computer For computer with Mini D-SUBFor Macintosh About DDC Adjustment of the projection angle After using the projectorPreparation Preparation for projection 3, 1 Power-onBasic operation Power-off Volume from the speakerBasic operation continued AUTO POSITION button XGA60 Menu operationBasic operation 1 IMAGE 2 INSTALLATIONMenu operation continued 5 SIGNAL - USER No need to adjust in normal use 3 FEATURE4 SIGNAL Image adjustment Image adjustmentTo adjust the red-green color balance of the image To adjust the detail and clarity of the image Adjustment of the image from the computer Simple adjustment methodWhen the image flickers or the image is out of focus When the top part of the image flags Advanced feature StillTo resume the motion in the image Page-up and page-down To enable the password function Password functionTo cancel the password function Reset of the lamp operation time Lamp replacementInterval of lamp replacement Troubleshooting Images aren’t projected on the screenProblem Cause and solution Troubleshooting continued Images aren’t projected correctly Maintenance Cleaning of the projector and the ventilation slotsCleaning of the lens Others Abnormal condition IndicatorsNormal condition Specifications Kensington LockKensington Technology Group 2855 Campus Drive San Mateo, CA 94403, U.S.A Specifications continued ConnectorsDimensional drawings unit mm What’s included in the box Specification of RGB signals in each computer mode of the projector Some computers aren’t compatible with the projector MITSUBISHI Projector Contact Information MITSUBISHI ELECTRIC CORPORATIONNorth America Europe

Mitsubishi Electronics XD110, SD110 Advanced feature, Still, To resume the motion in the image

Models: SD110 XD110

Advanced feature

Still

To resume the motion in the image:

Page-up and page-down

Connection