ProjectorView (continued)
Initial setting
To load information on the projector such as model name and lamp operating time, set the projector data in advance. Click the SETUP button on the ProjectorView main screen. The Projector Setup screen appears. Enter data according to the description of each setting item.
(Note)
•You can’t change the Projector model, Serial number, Operating hours, and Lamp hours. They are loaded from the projector and displayed when the LAN controlled mode of Telnet setting is set to ON.
•The entry field of each setting item contains a blank character by default. When setting these items, delete the blank characters.
Each setting item is described as follows:
Projector name* | Name to identify the projector |
|
|
Projector model | Model name of the projector |
|
|
Projector location* | Location of the projector |
|
|
Serial number | Serial number of the projector |
|
|
SMTP IP address* | IP address of the SMTP server used for |
|
|
| (up to 64 characters) |
|
|
|
|
Sender of alert notification | |
|
|
Operating hours | Cumulative projector operating time |
|
|
Lamp hours | Cumulative lamp operating time calculated based on that LAMP MODE is LOW. |
|
|
Installation date* | Date when the projector was installed |
|
|
Last lamp replacement date* | Date when the lamp was last replaced |
|
|
Last maintenance date* | Date when the projector was last maintenanced |
|
|
Virtual remote enabled | Display or hide the virtual remote controller (Check the box to display.) |
|
|
* ) For data entry, use
(Note)
When the “Standard” lamp mode is selected, the indicated lamp operating time may exceed the indicated operating time.
