Mitsubishi Electronics XD490U Preparing your projector, Checking accessories, Power supply parts

Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

Cables

		Mini D-SUB	Mini D-SUB
	USB 4-pin	15-pin
			9-pin
	(type B)
		Mini D-SUB	8-pin
	USB 4-pin	15-pin
	(type A)
Audio/Video cable	USB cable	RGB cable for PC	RS-232C cable
(246C381-10)	(246C509-10)	(246C521-10)	(246C508-10)

• Used for projector control by computer.

Power supply parts

Power cord (two)

(246C483-10, 246C383-20)

Remote control parts

Remote control	R6 (size-AA)
(290P136-10)	battery (two)

Others

•Lens cap (Attached to the projector)

•Quick Start up (857D064-90)

•CD-ROM (919C137-50)

•Safety manual (871D421-50)

•Carrying case (772P044-10)

Important:

• The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1	1.	Remove the rear lid of the remote control.
	2.	Check the polarity (+), (-) of the batteries, and set them
	3	correctly, inserting their (-) side first.

•If the battery is inserted from the (+) side first, inserting the (-) side is difficult because the coil spring end hits on the battery side. If the battery is forced to insert in this

2	way, the outer label of the battery may get ripped and it
	may cause a short-circuit and heating.
	3. Attach the rear lid.

Important:

• Use two size-AA batteries (R6).

• Replace the 2 batteries with new ones when the remote control is slow to operate.

CAUTION:

•Use of a battery of wrong type may cause explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Batteries may explode if misused. Do not recharge, disassemble, or dispose of them in fire.

•Be sure to handle the batteries according to the instructions.

•Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6