Using the remote control
Operational range of the remote control
Front of projector | Rear of projector |
30° | 30° | 30° | 30° |
Operate the remote control within a distance of 10 m (30 feet) from the projector, pointing the light beam at the remote control
•Keep the remote control
•Keep the remote control
•If there is an
•When you use the remote control too close to the remote control sensor, the remote control may not work correctly.
When operating the remote control, keep the distance from the remote control to the projector via the screen within about 5 m (15 feet). The operable range of the remote control, however, depends on the characteristics of the screen.
Reception angle
Vertical directions
20°
10°
Vertical directions (ceiling mount)
20°
20°
10°
20° 
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired remote control is useful for operating in a distance or outside of the operating area.
REMOTE IN
REMOTE IN | REMOTE OUT |
•For connection, use the
•When REMOTE OUT terminal on this projector is connected to the REMOTE IN terminal on the other projector, the two projectors can be controlled together by using the remote control.
•When the remote control is connected with remote control cable, it does not work as a wireless remote control.
•When using the wired remote control, the laser beam may be darker. It is normal.
•When using the remote control as wired for a long time period, remove the batteries from it. (Dispose of the removed batteries according to the cautions on page 6.)
