Mitsumi electronic XD3500U user manual Viewing computer images, Plugging the power cord, About DDC

Viewing computer images (continued)

Monitor

For monitor connection:

1.Connect the RGB cable from the monitor to the MONITOR OUT terminal of the projector.

•No video signal is output from the MONITOR OUT terminal during power standby.

1 MONITOR OUT

RGB cable

To audio input

For audio output connection:

1.Connect one end of a commercially available audio cable to the AUDIO OUT terminal of the projector.

2.Connect the other end (white and red) of the audio cable to the audio input terminals (L, R) of the audio equipment.

1 AUDIO OUT

terminals

2

• When the audio cable is connected to the AUDIO OUT

terminal, the speaker output is muted.

Audio cable (option)

About DDC

The COMPUTER/COMPONENT VIDEO IN-1 terminal of this projector complies with the DDC1/2B standard and the COMPUTER/COMPONENT VIDEO DVI-D IN (HDCP) terminal complies with the DDC2B standard. When a computer supporting this standard is connected to this terminal, the computer will automatically load the information from this projector and prepare for output of appropriate images.

•When connecting a DDC-supporting computer to the projector, turn on the main power switch of the projector before starting the computer.

B. Plugging the power cord

•In order to ensure the safety in case of trouble with the projector, use an electrical outlet having an earth leakage breaker to supply the power to the projector. If you do not have such outlet, ask your dealer to install it.

1. Plug the attached power cord into the power cord inlet of this projector.

2. Plug the other end of the power cord into a power outlet.

Earthing terminal

2

1

Power cord (example)

•One of power cords for the U.S., Europe and U.K. is provided appropriately.

•This projector uses the power plug of 3-pin grounding type. Do not remove the grounding pin from the power plug. If the power plug doesn’t fit your wall outlet, ask an electrician to change the wall outlet.

•In case that the power cord for the U.S. is provided with this projector, never connect this cord to any outlet or power supply using other voltages or frequencies than rated. If you want to use a power supply using other voltage than rated, prepare an appropriate power cord separately.

•Use 100-240 V AC 50/60 Hz to prevent fire or electric shock.

•Do not place any objects on the power cord or do not place the projector near heat sources to prevent damage to the power cord. If the power cord should be damaged, contact your dealer for replacement because it may cause fire or electric shock.

•Do not modify or alter the power cord. If the power cord is modified or altered, it may cause fire or electric shock.

Caution:

•Plug in the power cord firmly. When unplugging, hold and pull the power plug, not the power cord.

•Do not plug in or out the power cord with your hand wet. It may cause electric shock.

EN-14