Installation instructions continued
How to finish unpacking
•Place packed appliance next to the space in which it will be installed.
•Remove the appliance packing except for bottom tray, which should be left in position until the appliance is ready to be fitted into its cabinet.
IMPORTANT!
It is imperative that the appliance is left in the base to protect both the appliance and the floor.
•Ensure the user is given these operating instructions.
•Prise cover loose using screwdriver in position (1) then lever off with screwdriver in position (2) at either side.
•Lift cover and remove screw from cable clamp.
IMPORTANT!
Important: Switch off at the mains, miniature circuit breaker and if appropriate, remove fuse before commencing any electrical work.
To remove the mains terminal cover
•From the rear of the appliance, remove mains input terminal cover to gain access to terminal block.
•First remove retaining screw with pozidrive screwdriver.
34
Connecting to the mains terminal
WARNING!
This appliance must be earthed.
•We recommend you use a new length of 6mm2 twin core and earthed cable to ensure your safety.
•Make connection as shown below by proceeding as follows: -
•
•Strip inner insulation on wires using wire strippers.
