Installation
Water Connection
1.A cold water supply should be connected to the water inlet located on the rear right hand side of the unit.
2.A connection elbow and sealing washer are supplied with this unit for direct connection of a ¾” ID hose, and is recommended for easy installation and service.
3.Connect to the water supply.
- Max Inlet Pressure 80psi / 550kPa.
Water
Connection
4. Turn ‘On’ the water supply to check for water leaks.
NOTE: The Prover / Holding Cabinet can be fitted with an optional Water Filter Kit (Part No. 234347). For fitting instructions refer to the Instruction Sheet supplied with the Water Filter Kit.
5
