Monessen Hearth C2801VF Electrical Wiring Milli-Volt, Removing Face Plate from Stove, Screws

ELECTRICAL WIRING (MILLI-VOLT)

INSTALLING THERMOSTAT SENSOR (OPTION SOLD SEPARATELY)

1.Remove the face plate by removing the six screws holding the faceplate in place. This will allow you to pull the faceplate away from the unit about 3" to 4". See Figure 8.

2.Slip the t-stat sensor behind the faceplate. Attach the t-stat sensor to the faceplate with 2 screws provided. Make sure the thermo bulb wire is on the bottom of the t-stat sensor. See Figure 9.

3.Attach wiring harnesses to back of t-stat sensor. See Figure 8. Attach the other ends of the har- ness to either TP/TH and TH on control valve or to existing wiring harness with two (2) 0.250" male spade terminals for remote t-stat operation. See Figure 8, page 13.

�������������

Face Plate

Screws

���
��	�
	��
	��
	��
	�
	�

�
�
��
��
�	�
�
	�
	��
	�
	�
	��
	��

Figure 8 - Removing Face Plate from Stove

��

���
��	�
	��
��
��
	�
	�
Screws	�����
	�
	�
		� �
		�
		��
		�
		�
		��
		��

T-Stat	Wiring
Sensor
	Harnesses

Knob

Thermo

Bulb

Figure 9 - Installing T-Stat Sensor and Control Knob

14 45D0080