ELECTRICAL WIRING
4.Remove adhesive backing from plastic clip. Press clip to bottom of valve. Clip thermo bulb into plastic clip. See Figure 10.
5.Reattach faceplate or reinstall base.
6.Install knob to shaft of
OPERATION OF THERMOSTAT SENSOR
Valve
Thermo 
Bulb
Plastic Clip
Figure 10 - Clipping Thermo Bulb into
Plastic Clip.
1.Follow millivolt lighting instructions on lighting plate attached to unit or in homeowner’s manual.
2.With control knob in the “ON” position make sure the ON/OFF switch is in the “OFF” position. See Figure 11.
3.The unit is now being controlled by the thermostat sensor. The sensor will now cycle the burners on and off. You can adjust how often the unit cycles by turning the control knob on the sensor.
ON/OFF
Switch
Control
Knob
�� |
|
� |
|
� | � |
� | |
| � |
| � |
| � |
| � |
| � |
| � |
| � |
| � |
� |
|
� |
|
�� |
|
�� |
|
� | � |
� | |
| � |
| � |
| � |
| � |
| � |
| � |
| � |
| � |
| � |
Sensor
Figure 11 - Control Knob in “ON” Position and ON/OFF Switch in “OFF” Position
45D0080 | 15 |
