FIREPLACE CONFIGERATION INSTALLATION | 6 |
|
|
PART 1
Remove front glass door by removing the cardboard fillers at the top and lifting up and away from the appliance.
Install the handles onto the door using screws from the handle package.
Keep front glass door off of the appliance until installation of Configuration Kit (Part 2) and Control Kit (Part 3) are completed.
Remove carton containing logs. Retain for later installation.
Remove and dispose of the cardboard support for log carton.
Remove burner pan be removing two (2) screws. Replace screws in holes for later use.
Remove the hearth pan that burner was secured to by lifting it up and off of its four (4) locating pins.
PART 2
The appliance is now ready for one of the following configuration kits:
6BK | Bay Kit |
6CK | Corner Kit (Does left or right side open.) |
6IK | Island Kit |
6PNK | Peninsula Kit |
6SK |
Complete installation instructions are included with each kit.
PART 3
After installing the Configuration Kit (Part 2), the appliance is ready for one of the following control kits:
6CN | Control Kit Natural Gas Standing Pilot |
6CLP | Control Kit Propane/LP Gas Standing Pilot |
6CEN | Control Kit Natural Gas Electronic Ignition |
Complete installation instructions are included with each kit.
Once your Configuration Kit and Control Kit have been installed, install the hearth pan by positioning it down onto the four (4) locating pins, making sure the access panel is positioned over the controls.
The burner may now be installed onto the hearth pan. This is done by positioning the large opening in the burner, over the pilot protruding up from the control panel. Lower the burner around the pilot down onto the firebox bottom.
Looking through the large opening in the burner pan, positon the burner tube with air shutter onto the orifice mounted on the control panel.
The burner may now be secured at both ends with screws removed earlier.
Proceed with Installation.
53D9019. Rev 3 11/07