DFX & DBX Series Vent Free Fireplaces | FIREPLACE INSTALLATION |
SECURING HEATER TO FLOOR OR HEARTH
Note: Clearance requirements as detailed in “Clearances and Height Requirements” section on Page 16 of this manual, must be met before securing the heater in place.
To prevent movement, the heater must be secured to the floor or hearth.
1.Open the control access door and remove the screen.
2.Remove carton containing the
3.To remove the grate and base assembly, take out two (2) screws as shown in Figure 9.
4.Lift grate and base assembly out of the firebox.
5.Secure the firebox with two anchoring screws (3/16" x 1Z\v" length) supplied with the fireplace system. Figure 10
Note: If the unit is mounted on carpeting, tile or combustible material without the hearth, a metal or wooden base covering the entire width and depth of the base must be installed.
Screws
Grate
Figure 9 - Remove Grate
| Anchor Screws |
| 3/16" x 1Z\v" |
FP2515 | Figure 10 - |
|
Secure Heater to Floor or Hearth | FP2516 |
|
12 | 33D4047 |