Preinstallation information
| WARNING | • Gloves are recommended when handling |
|
| |
|
| ceramic fiber logs to prevent skin irritation |
|
| from loose fibers. Logs are fragile — |
|
| handle with care. |
|
|
|
GETTING STARTED
Make sure you have received all parts:
Check your packing list to verify that all listed parts have been received. You should have the following:
•Unvented gas heater
•Ceramic fiber logs
•Two (2) anchoring screws
•Installation/operating instructions
Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions.
•Hand held Remote with receiver
•Wall
•Wall switch with 20' wire
•Hand held Thermostat Remote w/receiver
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts in good condition.
What you will need for installation:
You must have the following items available before pro- ceeding with installation:
•External regulator (for propane/LPG only)
•Manual shutoff valve
•Piping which complies with local codes
•Sediment trap
•Phillips head screwdriver
•Tee joint.
•Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
•Pipe wrench
90D0093
Parlor Vent Free Fireplace
| WARNING | Do not install the heater: |
| • Where curtains, furniture, clothing, or | |
|
| |
|
| other flammable objects are less than |
|
| 42" from the front of the heater. |
|
| • In high traffic areas. |
|
| • In windy or drafty areas. |
|
|
|
In planning the installation for the fireplace it is necessary to determine where the unit is to be installed and whether optional accessories are desired. Gas supply piping should also be planned. The following steps represent the normal sequence of installation. Each installation is unique, how- ever, and might require a different sequence.
1.Position fireplace in desired location. Refer to the Loca- tion of Fireplace and Clearances and Height Require- ments, and Fireplace and Framing Dimensions sections found in this manual.
Note: Be sure all packing material has been removed from under the unit.
2.Install following the instructions found in this manual.
3.Field wire main power supply to light kit. Refer to the Electrical Section found in this manual. (Electrical con- nections should only be performed by an experienced, licensed certified tradesman).
4.Install optional ON/OFF kit on units with millivolt control. Refer to the installation instructions included with the kit and also refer to the Electrical Wiring section found in this manual.
5.Plumb gas line. Refer to the Connecting the Gas sec- tion found in this
manual. (Gas connections should only be performed by an experienced,
licensed/certified tradesman).
6.Complete finish wall material and/or surround.
